Water Butt Linking Kit
Product Information:
Easily link 2 water butts together for greater water storage capacity.
BEWARE Do not use an electric drill if the Butt contains water.
Fitting Instructions:
- Before drilling make sure both butts are facing each other with the taps at the front.
- The water butts to be connected should be on a level surface and no more than 39cm apart. The water butts can be connected at the bottom, then the two water butts will fill at the same rate. If connected at the top the first butt will fill then run over into the second.
Drill a 25mm diameter hole approx. 5cm from the top or the bottom into opposite sides of the water butts to be connected. Join the water butts together with the supplied hose. Push the connector through the washer from the inside of each butt, then fit and tighten the nut outside to form a seal.
KIT INCLUDES:
1 x 500mm Connector Hose
2 x 20mm Connectors
2 x Washers
2 x Nuts
KIT INCLUDES: 1 x 500mm Connector Hose, 2 x 20mm Connectors, 2 x Washers, 2 x Nuts
Will these fit any water butt even if I didn't buy it from you?
Yes, this is universal and will fit other water butts regardless of where you bought it.
DELIVERY CHARGES
Our standard delivery charge is £5.95 per order. For deliveries to the Highlands of Scotland, Northern Ireland and the Isle of Wight, an increased P&P charge of £14.95 will apply - see below for full details.
For orders over £100 in value after deduction of the online discount, we offer free P&P. No post code P&P surcharges apply.
Full details of delivery address post codes affected by the increased P&P charge are - AB31-35, AB36-38, AB41-54, AB55-56, BT, IV1-IV63, KW1-14, PH15-26, PH30-41, PH49-50, PA21-40, and PO30-41.