Screw In Ground Socket
Product Information:
Screw the socket in to the ground or sand with the bar supplied,
Can be easy relocated again and again,
Suitable for use with any rotary lines or parasols,
Fits from 17mm - 55mm Diameter poles
Instructions:
1. Remove the hanging tab
2. Insert the bar supplied through the top of the socket
3. Screw the socket into the ground
4. If the ground is too hard, wind the socket back slightly and pour water into the top hole and leave for a while (Repeat if required)
5. Finish screwing the socket into the ground
6. Suitable for pole diameters from 17mm - 55mm
7. Can be used with any rotary lines, small and large parasols, camping equipment, signs or sports nets
8. Secure the pole tightly by tightening the top nut
Suitable For Use With Any Rotary Lines Or Parasols, Fits From 17mm - 55mm Diameter Poles
My ground is quite hard, how will I get this in the ground?
The spike has several holes in it, so start the spike off in the ground as far as you can, then fill the top hole with water and allow it to drain through the spike in to the soil and leave overnight for the soil to soften. Then continue to screw the spike in to the ground and repeat as required until fully screwed in..
DELIVERY CHARGES
Our standard delivery charge is £5.95 per order. For deliveries to the Highlands of Scotland, Northern Ireland and the Isle of Wight, an increased P&P charge of £14.95 will apply - see below for full details.
For orders over £100 in value after deduction of the online discount, we offer free P&P. No post code P&P surcharges apply.
Full details of delivery address post codes affected by the increased P&P charge are - AB31-35, AB36-38, AB41-54, AB55-56, BT, IV1-IV63, KW1-14, PH15-26, PH30-41, PH49-50, PA21-40, and PO30-41.